• On Purchase - Before first use, Turn the dial on the vaporizer gun unit to 9, and place the trigger switch on 2 to heat the gun, let run at this level for 10 minutes. Turn the vaporizer gun unit switch to 1 so it can cool properly, allow gun to cool for 3 to 5 minutes.

• This burns off the manufacturers packing oils on the heating coils. Share your Vaporizer stories with the rest of the world.

CAUTION: To reduce the risk of electrical shock, do not remove cover or operate electrical devices in an unsafe manner.

Step One:
Fill the Inspector Vapors Water Pipe with enough water to cover stem. (Add ice to the tube for a cooler taste and feel.)

Step Two:
Place one of our glass screens in bottom of Inspector Vapors Custom Bowl, (Any screen will work.)

Step Three:
Turn the dial on the vaporizer gun unit to 4, and place the trigger switch on 2 to heat the gun.

Step Four:
Place about 1/8 to 1/4 gram of finely-ground tobacco into the vaporizer bowl.

Step Five:
Now take the vaporizer gun unit and switch it off right before you place it onto the bowl. (You need to switch the gun off because the hot air will blow your tobacco out of the Inspector Vapors Custom Bowl before you use it.)

Step Six:
Once you have fastened the vaporizer gun unit onto the Inspector Vapors Custom Bowl, restart it and wait a few seconds, when you see the vapors start to rise, start inhaling from the Inspector Vapors Water Pipe. The tobacco will not burn, when it turns a light brown and smells like over cooked popcorn you're done!

Step Seven:
Empty used tobacco.

Step Eight:
Repeat step four.

Step Nine:
When you have finished using the Vaporizer unit. Turn the vaporizer gun unit switch to 1 so it can cool properly, allow gun to cool for 3 to 5 minutes.

Check out the Volcano Vaporizer